Introduction: Abrasive monitoring is an important way to prevent and prevent mechanical failure, the use of iron meter can be detected in the early wear and tear mechanical parts, through the replacement can avoid serious losses, iron meter is a special measurement of PQ index of oil analysis equipment , PQ index is a unit without a quantitative figure, it is the sample with the iron content and particle size showed a good linear relationship. There are some defects and shortcomings in the existing abrasive grain monitoring methods. If the oil analyzer is limited by the carrying capacity and the excitation energy, the particles can not be quantitatively monitored more than 5μm. The result of the ferrography is only the relative coefficient but not the absolute concentration. And the use of iron meter without the need for oil samples for processing, can be directly measured in the oil sample of all the concentration of ferromagnetic abrasive; TTL-3 iron meter is a kind of oil for the wear of ferromagnetic particles of fast quantitative analysis equipment The The use of iron meter can be detected in the early wear and tear wear parts, through the replacement can avoid serious losses; Features: 1 patented sensor and signal processing circuit, good stability, high sensitivity, resolution up to ppm order of magnitude. 2 oil sample transfer, measurement automatically, 10 seconds to measure a data. 3 supporting the PC data management software, measurement data can be directly into the computer, data management, trend analysis, curve printing and so on. 4 oil samples without treatment, can be directly injected into the oil bottle for measurement. 5 Chinese and graphical interface, user operation easy to use. 6 use the micro switch button and the code knob input, you can enter any number and letters, the user name to the file. 7 easy to operate, do not need to do any processing can be directly detected, do not need any test supplies 8 detection speed, the detection of an oil only 1 minute to be able to out of the results; 9 detection of high precision, large amount of stored data. Technical indicators: Air gap center magnetic field strength: ≥ 1.5T Power supply: AC220V ± 10%, 50-60Hz Magnetic field gradient: ≥5.0T / cm Ambient temperature: 10 ℃ ~ 30 ℃ Detection of abrasive range:> 5μm ferromagnetic abrasive Display: LCD128 × 64 Measuring range: 0 ~ 15000PQ Weight: 7.5KG Length × width × height: 430 × 380 × 155mm USB connection: male to female type A USB cable Repeatability: Measure stable oil samples (eg 750 standard samples), repeat 100 measurements, 90% data falls within ± 1% (> 500PQ) or ± 5PQ (<500pq)
Introduction: Abrasive monitoring is an important way to prevent and prevent mechanical failure, the use of iron meter can be detected in the early wear and tear mechanical parts, through the replacement can avoid serious losses, iron meter is a special measurement of PQ index of oil analysis equipment , PQ index is a unit without a quantitative figure, it is the sample with the iron content and particle size showed a good linear relationship. There are some defects and shortcomings in the existing abrasive grain monitoring methods. If the oil analyzer is limited by the carrying capacity and the excitation energy, the particles can not be quantitatively monitored more than 5μm. The result of the ferrography is only the relative coefficient but not the absolute concentration. And the use of iron meter without the need for oil samples for processing, can be directly measured in the oil sample of all the concentration of ferromagnetic abrasive; TTL-3 iron meter is a kind of oil for the wear of ferromagnetic particles of fast quantitative analysis equipment The The use of iron meter can be detected in the early wear and tear wear parts, through the replacement can avoid serious losses;
