Brief introduction: Wire and cable single vertical burning test instrument is the most widely used and low cost of cable fire resistant performance testing instruments; This single cable combustion tester meet the national standard GB / / IEC60332 T18380.11-2008-1-1:4 stipulated in the specifications and requirements, apply to under the condition of the flame, used for testing cable in overheated, over-current and other abnormal conditions, its flame retardant properties of the insulating layer. Can be used in wire and cable or optical cable vertical flame spread of test, and at the same time can test under the condition of flame did combustion conditions. Features: 1. Touch screen smart control system; In both Chinese and English operation interface (optional) 2. The system automatic ignition, automatic timing, data automatic storage; 3. The test part and control part adopts the integrated design, convenient installation and debugging. 4. All stainless steel body, internal cavity height is 1200 mm, width 300 mm, a depth of 450 mm; 5. Two stainless steel rod, perforation and bolted joint cable or cable sample; 6. The burner for the hybrid, inner diameter for ¢12 + / - 0.5 mm, about 100 mm long. 1 kw hybrid standard burner, can provide accurate test fire; 7. Applying time and flame combustion time can within the scope of 0 ~ 99 points in 99 seconds. Test process automatic control. 8. Import of needle valve to adjust the flame height, according to the standard blue flame 50 mm ~ 60 mm, total height of 170 mm to 190 mm 9. The needle valve control gas flow 10. Equipped with flame height caliper. Technical parameters: Working voltage: 50 hz AC 220 v + 10 v; Temperature: room temperature ~ 40 ℃; Gas pressure: 0.1 MPa : gas purity propane > 95%; The compressed air Timing accuracy: 0.1 s; Size: 600 (W) x 450 x 1250 mm (H) (D) Power supply: AC 220 v, 50/60 hz, 3 a Weight: 60 kg
Brief introduction: Wire and cable single vertical burning test instrument is the most widely used and low cost of cable fire resistant performance testing instruments; This single cable combustion tester meet the national standard GB / / IEC60332 T18380.11-2008-1-1:4 stipulated in the specifications and requirements, apply to under the condition of the flame, used for testing cable in overheated, over-current and other abnormal conditions, its flame retardant properties of the insulating layer.