WSY-025HX Asphalt Softening Point Tester Introduction: This equipment is suitable for determining the softening point of residues from road petroleum asphalt, polymer modified asphalt, cutback asphalt, and emulsified asphalt. Applicable standards: GB/T 4507, JTG 3410-2025/T0606 (new standard) Features: 1. Equipped with a 10-inch high-performance industrial computer, it boasts an aesthetically pleasing appearance and ergonomic design, and can interface with platforms for data upload. 2. A ceramic glass electric hot plate with magnetic stirring is adopted, and the temperature control method adopts bottom heating, which meets the requirements of the new standard; the temperature rise rate is automatically controlled within the standard range (5±0.5℃/min) through PLC, and the temperature rise curve is displayed in real time. 3. It features two test modes, high and low temperature, which are switchable, and also incorporates an overtemperature protection function. (1) When the softening point is ≤80℃, the temperature rise rate reaches and stabilizes at 5℃/min ± 0.5℃/min within 3 minutes; (2) When the softening point is greater than 80℃, after the test temperature reaches 60℃, the heating rate stabilizes at 5℃/min ± 0.5℃/min. 4. Equipped with a magnetic stirring function to ensure uniform temperature within the beaker; the stirring speed is adjustable, and a high-precision stepper motor speed measurement device is equipped, displaying real-time speed (r/min) on the test interface. 5. The automatic detection and recording of ball drop can be achieved through photoelectric detection technology, eliminating the need for manual operation. The equipment features both manual and automatic detection modes, allowing for switching between modes according to actual testing needs. 6. The device features a multi-point temperature calibration function, which enables the displayed temperature to closely match the actual temperature measured by the thermometer through calibration. 7. The equipment is equipped with a cooling and heat dissipation system, which automatically starts to cool the equipment after the test is completed The heating device achieves local high-efficiency heat dissipation, effectively reducing the interval time for secondary testing. 8. The equipment is equipped with a USB interface, allowing for the export of test data and temperature rise curve graphs. Technical Specifications: Temperature measurement range: 5℃~180℃ (when the softening point is ≤80℃: 5℃~90℃; when it is >80℃: 32℃~180℃) Temperature resolution: 0.1℃ Heating rate: 5℃/min ± 0.5℃/min Stirrer and oscillator size: Φ8mm×40mm Stirring speed range: 0~180r/min (adjustable) Steel ball diameter: 9.5mm Steel ball weight: 3.5±0.05g Beaker capacity: 800ml Rated total power: 1.5 kW Power supply voltage: AC (220±10%) V/50Hz The ambient temperature is between 20℃ and 30℃; Relative humidity ≤ 80%RH Overall dimensions: 360×370×560mm
WSY-025HX Asphalt Softening Point Tester Introduction: This equipment is suitable for determining the softening point of residues from road petroleum asphalt, polymer modified asphalt, cutback asphalt, and emulsified asphalt. Applicable standards: GB/T 4507, JTG 3410-2025/T0606 (new standard)