| Measurement items | |
| Measurement items | Roundness, cylindricity, concentricity, coaxiality (multi-element), straightness, perpendicularity (multi-element), runout (axial, radial), full runout (axial, radial), planeness (multi-element), parallelism (multi-element), Notch removal, corrugation, spectral analysis, wave height analysis, harmonic analysis, diameter, taper (vertical, plane), wall thickness deviation |
| Measuring range | |
| Maximum measured diameter | φ200mm |
| Maximum measured height | 280mm |
| Load capacity | 15Kg |
| Spindle precision | |
| Spindle radial error H = height of table | ±(0.04+5H/10000)μm |
| Spindle axial error X = distance from spindle center | ±(0.04+6X/10000)μm |
| Staging | |
| Mesa diameter | φ150mm |
| Adjusting range | Adjust eccentricity ±2mm; adjust level ±1 ° |
| Turning diameter | φ200mm |
| Rotation speed | 0-12 rpm / min |
| Z axis (column) | |
| Straightness (narrow range) | 0.8μm/100mm |
| Straightness (full range) | 1.0μm/200mm |
| Grating resolution | No |
| Parallelism between the axis of rotation and the guide rail of Z axis | |
| Parallelism between the axis of rotation and the guide rail of Z axis | 2μm /250mm(Bus datum) |
| Horizontal arm (transverse guideway) | |
| Moving precision | 2μm/150mm |
| Horizontal moving distance | 140mm |
| Grating resolution | No |
| Sensor | |
| Range | 500μm (Radius difference) |
| resolution ratio | 0.005μm |
| Needle shape | 2mm gemstone ball probe (more diameters optional) |
| Dynamometry | 1-12g |
| Data collection | |
| Data collection | 3600 points / week (international) |
| Amplified factor | |
| Amplified factor | 200000 times automatic |
| Evaluation method | |
| Evaluation method | LSC (least square), MZC (minimum region method), MIC (maximum tangent circle method), MCC (minimum circumscribed circle method) |
| Filter value | |
| Filter value | 1-500、1-150、1-50、1-15、3-16、3-17、15-500、17-100 upr |
| Data analysis and processing | |
| Frequency analysis | Analysis of amplitudes of different Frequency components |
| Abnormal data elimination | Manually or automatically remove abnormal data, such as burrs, holes and bumps, etc. |
| File management | Automatically save measurement data, can be deleted |
| Data printing | Single or multiple measurements can be printed in the same page mode |
| Installation requirements | |
| Power supply | 220-240v AC, 50HZ, separate ground wire;Maximum power consumption is 450W |
| Compressed air | Pure compressed air: pressure 0.4mp, consumption 0.1m3 /min (air source supply 0.6mp, 0.25m3 /min and above) |
| Environmental requirements | Working temperature: 10 ° to 30 ° (room temperature).Humidity 20-80%RH (no condensation), good ground line, no obvious source of vibration |
Please inquire
Please inquire
Please inquire
Please inquire
