SYD concrete flexural and compressive strength testing machine
Introduction: This testing machine is mainly used for the flexural strength test of concrete specimens and the compressive strength test of building materials such as cement, mortar and red brick. It can also be used to test the compressive strength of non-metallic materials such as mortar test blocks and concrete rapid test blocks. The product meets the requirements of GB/T3722 standard, adopts hydraulic loading, electronic force measurement, with load digital display, loading rate display, maximum load display, and overload protection and power failure data retention functions. Features: 1. The machine adopts high-precision sensor and digital display instrument (with computer system, it can also store, check and print test results). 2. The machine adopts a rotating screw to adjust the compression space, which greatly accelerates the test progress. 3. Add flexural attachments for flexural testing. 4. The machine does not need to be debugged, it landed steadily, and it can work after refueling and powering on. 5. The machine is easy to calibrate, and users can calibrate it according to the "Instruction Manual". Technical Parameters: 1. Maximum load: 30KN, 50KN, 100KN, 200KN, 300KN multiple ranges for selection 2. Relative error of indication: ±1%; 3. Rated pressure of hydraulic pump: 25MPa; 4. Diameter of anti-folding roller: 30mm; 5. The maximum distance between the upper and lower anti-rollers: 165mm; 6. The center distance between the two anti-folding rollers: 150mm; 7. The center distance between the two anti-folding rollers: 450mm; 8. Bearing board ruler: 155mm; 9. The maximum distance between the upper and lower pressing plates: 230mm 10. Piston diameter and maximum stroke: 125mm×80mm; Piston stroke: 120mm; 11. Motor power: 0.75KW 12. Dimensions: (determined when leaving the factory) 850×600×1340mm;
Introduction: This testing machine is mainly used for the flexural strength test of concrete specimens and the compressive strength test of building materials such as cement, mortar and red brick. It can also be used to test the compressive strength of non-metallic materials such as mortar test blocks and concrete rapid test blocks. The product meets the requirements of GB/T3722 standard, adopts hydraulic loading, electronic force measurement, with load digital display, loading rate display, maximum load display, and overload protection and power failure data retention functions.
