Introduction:
The tester is used to evaluate the performance of engineering plastics, powder metallurgy, etc. in the form of sliding friction on the end face under specified technical conditions, and to measure the wear resistance and material matching characteristics of the material. The test can be performed under various conditions such as changing the load, speed, time, friction partner material, surface roughness, hardness, and test environment temperature. The whole process can be controlled by the computer. The system software can monitor and control the test process in real time and record the relevant test parameters and curves. Technical Parameters:
1 Test force
Test force range 50～5000N
Test force accuracy ±1%
The loading and unloading test force should be stable and there should be no impact and pulsation
When the test force is long, the error of indication change is maintained ±1%FS
2 Friction
Large friction 300N(15N.m)
Friction accuracy ±2%
Spindle speed 1～2000 r/min
Spindle speed error 1～100r/min ±1r/min
100～2000r/min ±1%
Spindle speed display range 0～999999999 rpm
Time and temperature
Time display range 1s～99999 min
Temperature control range -50～1000°C
Introduction:
The tester is used to evaluate the performance of engineering plastics, powder metallurgy, etc. in the form of sliding friction on the end face under specified technical conditions, and to measure the wear resistance and material matching characteristics of the material. The test can be performed under various conditions such as changing the load, speed, time, friction partner material, surface roughness, hardness, and test environment temperature. The whole process can be controlled by the computer. The system software can monitor and control the test process in real time and record the relevant test parameters and curves.
