GF-300 dry powder generator Introduction: This equipment is a new type of dry powder generation device that combines heating and compressed air injection. By producing a certain concentration of dry powder particles, it can be specifically used for particle counter and dust detector calibration and particle size analysis experiments, as well as for drug inhalation research, toxicity experiments, and other environments. This device can be customized for appearance according to user needs. Features: (1) Particle fogging channel with adjustable flow rate. (2) The atomization device uses a clean and dry air source, which is dried by a dryer and filtered by an air filter, improving the effect of mixed drying. (3) Equipped with a special cutting and separation device combined with a mixed balance distributor, it ensures the continuous sending of dry powder particles with uniform and stable particle sizes. (4) The device adopts a configuration touch screen control, which is simple and convenient to operate. Technical parameters: Measurable particle size range: (1) Determine based on the particle size of the emitted particles (2) The particle size of the cyclone cutting separator can be controlled between 0 and 10 μ m. Efficiency can reach around 85% Gas flow range: ≤ 70L/min ≤ 200L/min Pressure range: (0-1) Mpa adjustable Concentration range: (0.1-100) mg/m3 Stability error: ± 10% Equipment control mode: manual mode and automatic mode Motor speed: (500-200) rpm (2500-7000) rpm
Introduction: This equipment is a new type of dry powder generation device that combines heating and compressed air injection. By producing a certain concentration of dry powder particles, it can be specifically used for particle counter and dust detector calibration and particle size analysis experiments, as well as for drug inhalation research, toxicity experiments, and other environments. This device can be customized for appearance according to user needs.
