BSD-660 surface area and pore size analyzer characteristic: 1. Full functionality: specific surface area, mesoporous, microporous, and ultramicroporous analysis; 2. High throughput: optional analysis bit rates of 3/6/9/12; 3. Fully automatic: degassing → testing, fully automatic switching; 4. High configuration: Optional dual station dual molecular pump set, molecular pump degassing; 5. Pollution prevention: Micro porous samples are subjected to "pressure controlled heating" to prevent pollution and degassing; 6. Zero helium pollution: first measure the temperature in the helium gas temperature zone, and then automatically degas; 7. Automatic cycle: automatic evaluation of material cycle adsorption performance; 8. Conventional gas adsorption: such as N2, O2, Ar, CO, CO2; 9. Adsorption of combustible gases: such as H2, CH4, C2H6 and other alkanes and alkynes; Technical parameters: Wide testing range: specific surface area above 0.0005 ㎡/g, pore size 0.35-500nm; Testing efficiency: multi-point BET (excluding degassing process), standard mode 12 samples/60 minutes; Rapid testing mode with 12 samples per 15 minutes; High testing accuracy: specific surface area, pore size, pore volume, adsorption capacity, quantitative error<0.5% RSD (based on BET value of standard sample); Program heating and degassing: Software controls program heating, room temperature -400 ℃, accuracy better than 0.1 ℃; Intelligent degassing completion judgment: supports software automatic judgment, automatically judges the degassing effect based on pressure changes; Anti flying degassing: "Program controlled pressure"+"Program controlled temperature"+"Degassing furnace lifting"="Pressure controlled temperature rise"; Vacuum degree: The vacuum degree can reach 10-9Pa;
characteristic: 1. Full functionality: specific surface area, mesoporous, microporous, and ultramicroporous analysis; 2. High throughput: optional analysis bit rates of 3/6/9/12; 3. Fully automatic: degassing → testing, fully automatic switching; 4. High configuration: Optional dual station dual molecular pump set, molecular pump degassing; 5. Pollution prevention: Micro porous samples are subjected to "pressure controlled heating" to prevent pollution and degassing; 6. Zero helium pollution: first measure the temperature in the helium gas temperature zone, and then automatically degas; 7. Automatic cycle: automatic evaluation of material cycle adsorption performance; 8. Conventional gas adsorption: such as N2, O2, Ar, CO, CO2; 9. Adsorption of combustible gases: such as H2, CH4, C2H6 and other alkanes and alkynes;